MOTOLOGY MOTOR

Detil Produk :

PT SARANA TEKNIK GEAR MOTOR ....

MOTOLOGY ELECTRIC MOTOR 3 PHASE

EMIAL : SARANAGROUP@CBN.NET.ID

TEL 021-6519582-  FAX  021- 65305868
 

Frame：80~355
Rated power：380V
Rated frequency：50HZ
Speed：3000rpm, 1500rpm, 1000rpm
Power scope：0.75~315KW
Mounting：IMB3 and other mounting type available
Protection class：IP55
Cooling type：IC411
Insulation：F class
Connection Mode: 3kW and below for Y connection; other power for △ connection
Temperature range: -15°C ~40°C
Humidity:  No above 90% while 25℃

Introduction:
      The series (IP55) high efficiency three-phase asynchronous motor is a fully enclosed self-ventilated three-phase asynchronous motor with high energy efficiency limit.
      The installation size and power level accord with IEC standards. The terminal box  is at the top outlet. The efficiency value fully achieve the energy efficiency level 3 (is energy efficiency level 2) requirements in GB18613-2012 《Energy Efficiency Limits and Energy Efficiency Grades of Small and Medium-sized Three-phase Asynchronous Motors》of energy efficiency 3 class (is 2 class energy efficiency ),keeping touch with international IEC60034-30《Single speed three-phase squirrel cage induction motor efficiency classification》of IE2 (IE3).This series of motors adopts cold-rolled silicon steel sheet as magnetically conductive material,the efficiency according with European Eff1 standard .To achieve advanced technology in domestic and abroad . This motor will advertise greatly replacement products.
     The motor has a shaft extension, which can be designed two shaft extension according to customers ,The second shaft extension can also transmit the rated power, but it can only be driven by the coupling.
     It can also supply other power, voltage, frequency, wet heat (TH), protection class and other motors ,According to user needs,.
 
Advantages:
High efficiency 、energy saving 、low noise 、high torque、low vibration、light weight、reliable running 、easy maintenance
 

Detil Produk :

PT SARANA GEAR MOTOR

EMAIL : SARANAGROUP@CBN.NET.ID

MOTOLOGY MOTOR provide specifications for electrical equipment with the intention of creating internationally recognised standards. Throughout the world electrical drive units are responsible for using 30%-40% of all electricity produced. Up to two thirds of that energy consumption could be saved by thoroughly implementing these standards. The latest EU legislation means that all electrical drive units produced must conform to a minimum requirement. There are three categories which make up these standards. They are: IE1 Motors = Standard Efficiency IE2 Motors = High Efficiency IE3 Motors = Premium Efficiency The reason these tiers exist is to provide options for the body that commissions the manufacture of a system which contains an electrical drive unit. For short term or temporary implementation the cost effectiveness of a premium efficiency unit cannot always be justified. However a long term or permanent system would make good use of an electrical drive that provides the same result at a lower running cost (even though the initial cost is higher). All of the products TEC Electric Motors supply conform to these standards.

GEARBOX MOTOR

64646